NStor Technologies Disk Array Enclosure User Manual download pdf (Page 60)

Using the CR8e

Options Menu

NOTE:

When the SAF-TE card is set to off bus, LEDs and other error reporting

are not driven by the subsystem’s off bus SAF-TE card, but are reported

and controlled from the “Master” subsystem’s SAF-TE card.

Reset Default IDs Selection

Choosing the “Reset Default IDs” option will reset all subsystem SCSI IDs to their

factory default settings.

The default drive ID settings when a dual-bus module is installed are 0, 1, 2, and

4 for both the upper and lower drive groups.

The default drive ID settings when a single-bus module is installed are 0, 1, 2, 4,

5, 6, 8, and 9.

The default SCSI ID for the SAF-TE card is ID 3. SCSI ID 7 is reserved for the

host bus adapter.

NOTE:

You must power cycle the subsystem for the SCSI IDs changes to take

effect. Also be sure to power cycle the host computer. If a PCI-based

RAID Controller is being used and the host is not power cycled, it will

“kill” all drives in the array.

1 To reset the SCSI IDs, access the Main menu and choose Options Menu.

2 Use the up/down arrow buttons to select SCSI ID Menu and press the Enter

button.

3 Use the up/down arrow buttons to select RESET DEFAULT IDS.

4 Press the Escape button twice to return to the Main “Status OK” screen, then

power cycle the host computer and CR8e subsystem.

MENU ENTER ESCAPE

RESET DEFAULT IDS

nStor

SET UPPER SLOT IDS

SET LOWER SLOT IDS

SET SAFTE ID

MENU ENTER ESCAPE

DUAL BUS MODE

ALL SCSI IDS SET TO

EFFECT CHANGES)

(CYCLE POWER TO

nStor

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 60