NStor Technologies Disk Array Enclosure User Manual download pdf (Page 37)

Installation

Ultra Wide SCSI Mode

3 Turn on the power to the CR8e. After the power-on self-test has completed,

Status and Channel Mode LEDs will be solid green.

4 Access the Options menu on the Operator Control Panel and choose the

SAFTE CHAIN ID selection. Choose the “None” selection, refer to “SAFTE

CHAIN ID” on page 50.

5 After setting the cabinet identiﬁcations you must power cycle the subsystem.

Observe normal power cycling precautions by waiting a minimum of ﬁve (5)

seconds before adding power again.

This will reset the SCSI IDs to a default setting that prevents a SCSI ID

conﬂict under normal conditions.

6 Power up your computer system and run the conﬁguration program.

This completes the hardware installation.

NOTE: For additional conﬁguration options using Ultra Wide SCSI, refer to the

nStor Feature Card User’s Guide.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 37