NStor Technologies Disk Array Enclosure User Manual download pdf (Page 58)

Using the CR8e

Options Menu

From the Options Menu the following are available:

■ SCSI ID Menu

■ Heat Threshold

■ SAFTE Chain ID

■ Change Passcode

■ Unlock Options

SCSI ID Menu

From the SCSI ID Menu you can set SCSI IDs for drives attached to each of the

SCSI channels (lower slot and upper slot), and set the CR8e SAF-TE processor ID

(upper or lower bus if a Dual-bus module is installed).

You can manually set SCSI IDs for each group of drives from a pre-deﬁned table of

IDs, see JP4 (SCSI ID Settings) on page 74 for a list of the possible ID combinations.

The SCSI IDs which are currently set will be ﬂashing. The IDs will be assigned

sequentially beginning with the lowest device in the group.

NOTE:

Drive SCSI IDs cannot be set individually.

1 To manually set the SCSI IDs for the drive sets found in the upper or lower

slots, access the Main menu and choose Options Menu.

2 Use the up/down arrow buttons to select SCSI ID Menu and press the Enter

button.

3 Use the up/down arrow buttons to select either the Lower or Upper drive slot

IDs, or the SAFTE ID, and press the Enter button.

MENU ENTER ESCAPE

SCSI ID MENU

HEAT THRESHOLD

SAFTE CHAIN ID

CHANGE PASSCODE

nStor

MENU ENTER ESCAPE

nStor

RESET DEFAULT IDS

SET UPPER SLOT IDS

SET LOWER SLOT IDS

SET SAFTE ID

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 58