NStor Technologies Disk Array Enclosure User Manual download pdf (Page 31)

Installation

Component Installation

Installing the Third Power Supply

If you will be installing ﬁve (5) or more disk drives you will be required to install

the third power supply.

CAUTION: Power supply installation is to be performed by qualiﬁed service

personnel only. There is no need to power off the CR8e or the

computer system. The power supplies are hot swappable.

1 Loosen the two screws on the Power Supply #3 cover plate using a ﬂat-blade

screwdriver and remove the cover plate.

2 Remove the power supply from its shipping package.

3 Install the third power supply by sliding the PSU into the cabinet until it

reaches its locked position. Orient the supply as indicated in the illustration.

NOTE: Use care when inserting the power supply into its fully seated position.

Do not use a strong force to seat the PSU into its mating connector.

4 Remove the blanking plug for the LED on the cover plate.

5 Re-install the cover plate. Secure the cover plate with the two screws using a

ﬂat-blade screwdriver securing the power supply.

Power Supply #3

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 31