NStor Technologies Disk Array Enclosure User Manual download pdf (Page 61)

Using the CR8e

Heat Threshold

NOTE:

The Heat Threshold value is pre-set at the factory and should not be

changed unless directed by nStor Technical Support. The default setting

is 116°F/47.°C.

Choose the Heat Threshold Menu to change the temperature value for the

thermal monitoring system. If the temperature exceeds the value set here, a

“Temperature Threshold Exceeded” screen will appear, see Internal Temp on

page 45.

1 Use the up/down arrow buttons to select Heat Threshold and press the Enter

button.

2 Using the up/down arrow buttons, change the temperature threshold setting.

The up arrow button will increase the temperature and the down arrow

button will lower the temperature threshold. The temperature value will

change by 2°C increments.

3 Press the Enter button the set the new temperature value.

4 Press the Escape button twice or press the Menu button to return to the Main

“Status OK” screen, then power cycle the host computer and CR8e

subsystem.

MENU ENTER ESCAPE

ENTER TO SET

ARROWS TO CHANGE

116°F / 47°C

ESC TO EXIT

nStor

MENU ENTER ESCAPE

nStor

SCSI ID MENU

HEAT THRESHOLD

SAFTE CHAIN ID

CHANGE PASSCODE

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 61