NStor Technologies Disk Array Enclosure User Manual download pdf (Page 39)

Installation

Fast Wide SCSI Mode

2 Connect the other end of the ﬁrst data cable to the Channel #0 SCSI

connector on the right side or upper I/O Interface card.

3 If required, connect one end of the second one meter data cable to the

Channel #2 connector on the AM RAID Controller.

4 Connect the other end of the second data cable to the Channel #1 SCSI

connector on the right side or upper I/O Interface card.

NOTE: SCSI termination is automatic and requires no user conﬁguration. Refer

to “Termination” on page 21 for information on systems using DEC

Fault bus protocol.

5 Turn on the power to the CR8e. After the power-on self-test has completed,

Status and Channel Mode LEDs will be solid green.

6 Access the Options menu on the Operator Control Panel and choose the

SAFTE CHAIN ID selection. Choose the “None” selection, refer to “SAFTE

CHAIN ID” on page 50.

7 After setting the cabinet identiﬁcations you must power cycle the subsystem.

Observe normal power cycling precautions by waiting a minimum of ﬁve (5)

seconds before adding power again.

This will reset the SCSI IDs to a default setting that prevents a SCSI ID

conﬂict under normal conditions.

8 Power up your computer system and run the conﬁguration program.

This completes the hardware installation.

Rear View CR8e

with Dual-Bus Module installed.

TOP

I/O Interface

Card

1 meter data cable

I/O Interface

Card

Ultra SCSI

RAID Controller

Ch 0

Ch 1

Ch 0

Ch 1

Ch 2

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 91 92

No comments

NStor Technologies Disk Array Enclosure User Manual Page 39